air compression
英 [eə(r) kəmˈprɛʃən]
美 [er kəmˈprɛʃən]
网络 活塞式空气压缩机; 空气压缩; 压缩空气
双语例句
- An investigation of squish air motion in compression ignition engines
压燃式发动机中挤流运动的研究 - This paper introduces the selection and arrangement of the air compressor and the air tank in the design of the gas system, the arrangement of the pipelines, instruments and valves, and the automatic control design of the air compression system.
介绍了气系统设计中空压机和气罐选择与布置，管路、仪表、阀门的布置，以及压缩空气系统的自动控制设计。 - For the UAV, which is low speed, small scaled and nature stability, not only the variety of aerodynamicist parameter, caused by the air compression, could be neglected, but also its pitch short period mode has good static and dynamic state characteristic.
对于低速、自然稳定的小型无人机，不必考虑空气压缩效应引起的飞机气动参数变化，而且它的纵向短周期模态稳定并具有良好的动态特性。 - Installation and application of ion-stick in circulation water system of the air compression station are presented and the application effect is analyzed.
介绍了离子棒在空压站循环水系统中的安装使用情况，并对其使用效果进行了分析。 - Wet compression process has great difference from general dry air compression process, so need to reserch in theory.
湿压缩热力学过程与干压缩过程比较来说发生了很大的变化，需要自理论上加以研究。 - Most of plants need to use air compressor to compress air, air compressor in air compression process will produce a lot of heat, resulting in compression of air temperature.
绝大部分工厂都需要使用空气压缩机压缩空气，空压机在压缩空气过程中会产生大量的热量，导致压缩空气温度升高。 - Compared with the DTT of steam compression, the DTT of air compression has lower cooling efficiency, larger equipment volume and greater investment. Therefore equipment such as pressure injector and turbine-pipe etc.
与蒸汽压缩式制冷技术相比较，空气压缩式制冷设备制冷系数低、体积大、投资大，研制的压力引射器、涡流管等设备多用于局部降温。 - Based on polytrophic process of air compression and isothermal gas combustion inside the turbine, an improved gas turbine with generality Carnot cycle is suggested. Its performance has been predicted with a mathematical model compared with traditional gas turbine.
基于气体多变压缩以及等温涡轮燃烧技术，提出了一种改进的概括性卡诺循环燃气轮机，通过模型预测分析了其性能，并与传统燃气轮机进行了比较。 - Bending fatigue test for crankshaft of air compression machine based on FEA
基于有限元分析的空压机曲轴弯曲疲劳试验 - This work introduces the general requirements and design method of each unit mode for the process system design of air compression station.
介绍空压站工艺系统设计的一般要求和各单元模式的设计方法。